Is a cobot safe by itself?
No. There is no "safe cobot", only a "safe collaborative application". The cobot's force limiting and collision detection are a strong foundation, but the part being carried, the end tool, speed, direction of motion and the operator's body region all change the level of risk.
That is why each cell gets its own risk assessment, and the required measures follow from it.
What do ISO 10218-1 and ISO 10218-2 cover?
ISO 10218 is the core safety standard for industrial robots and has two parts. Part 1 addresses the robot manufacturer: safety requirements for the design of the robot and its controller, such as safety functions, stop categories and speed monitoring.
Part 2 addresses the integrator: safety requirements for placing the robot in a cell, including the end tool, peripheral equipment, guarding and layout. Both parts were revised in 2025, and much of the collaborative application content of ISO/TS 15066 was brought into the ISO 10218 series. Which edition applies to a project should be decided with the lists of harmonised standards in mind.
What are the collaborative operation modes in ISO/TS 15066?
ISO/TS 15066 and ISO 10218 describe four collaborative methods. More than one can be used in the same cell.
| Mode | How it works |
|---|---|
| Safety-rated monitored stop | The robot stops and holds safely when the operator enters the shared space, then resumes when the operator leaves. |
| Hand guiding | The operator moves the robot by hand with a guiding device on the arm; used for teaching and positioning heavy parts. |
| Speed and separation monitoring | Sensors track the operator's distance; the robot slows down or stops as a person approaches. |
| Power and force limiting | Contact is possible, but transferred force and pressure stay below limits defined per body region. |
How is a risk assessment done for a cobot cell?
The risk assessment follows the ISO 12100 method and covers the whole life cycle of the cell.
- Define the limits and intended use of the cell, including foreseeable misuse.
- Identify hazards: impact, crushing, sharp edges, falling parts, tool-related risks.
- Estimate and evaluate the risk of each hazard.
- Select measures: first inherently safe design, then safeguarding, and finally information for use.
- Determine and validate the required performance level of safety functions (ISO 13849-1).
- Where power and force limiting is used, verify contact forces by measurement.
CE marking and the Machinery Safety Regulation in Turkey
In Turkey, machinery is placed on the market and put into service under the Machinery Safety Regulation, which is aligned with the EU Machinery Directive 2006/42/EC. A cobot arm on its own is usually treated as "partly completed machinery" and supplied by its manufacturer with a declaration of incorporation.
Once the arm is combined with an end tool and peripheral equipment into a working cell, the resulting machine goes through conformity assessment: risk assessment, technical file, instructions, EC declaration of conformity and CE marking. The EU Machinery Regulation (EU) 2023/1230, which will replace 2006/42/EC, should also be followed; the transition timeline in Turkey should be verified with the competent ministry.
In addition, under Occupational Health and Safety Law No. 6331, the employer is responsible for assessing workplace risks. Coborel Robotics treats the cell risk assessment and safety design as part of the project.
This guide is general information; programme and regulatory conditions change, so confirm current details with the institution.