A consistent bead
Robot speed is matched to dispense flow, so bead width and cross-section stay the same part to part.
06 · Solutions
A gluing robot applies adhesive, silicone or sealant from a dispensing unit along a path on the part at a constant speed and flow rate. Coborel Robotics integrates Dobot cobots with dispensing equipment and, where needed, machine vision so you get the same bead width and cross-section on every part.
Gluing
Cobots offer precision and consistency in the gluing process. They can handle various gluing techniques while maintaining product quality and integrity.
Robot speed is matched to dispense flow, so bead width and cross-section stay the same part to part.
Over-application and squeeze-out drop, reducing clean-up and scrap.
Corners, radii and 3D contours are followed at the same angle along the programmed path.
An optional camera checks bead presence and continuity right after dispensing.
We define the material (1K or 2K, hot melt, silicone), viscosity, cure time and target bead size.
We select a pump, valve and nozzle suited to the material and connect them so flow is synchronised with robot speed.
We design a locating fixture and add vision for path correction if part position varies.
We teach the path, tune build-up at start and end points, and verify results with you on sample parts.
We do the risk assessment, define measures for hot melt or chemical hazards, and commission the cell.
Dobot CR5A is a general-purpose 6-axis collaborative robot with a 5 kg payload and 900 mm reach.
Dobot CR10A is a 6-axis collaborative robot with a 10 kg payload and 1,300 mm reach.
Dobot Nova 5 is a compact 6-axis collaborative robot with a 5 kg payload and 850 mm reach.
Coborel Robotics commissions Dobot cobots at automotive suppliers for CNC and press tending, screwdriving, welding, gluing and vision-based quality inspection.
ExploreCoborel Robotics installs compact Dobot cobots at electronics manufacturers for small-screw assembly, board and module loading, test station tending, dispensing and visual inspection.
ExploreCoborel Robotics builds Dobot cobot cells for home appliance makers and their suppliers, covering screwdriving, adhesive and sealant dispensing, part feeding and vision inspection.
ExploreCoborel Robotics installs Dobot cobots at plastic injection plants for part removal, sprue and flash trimming, visual inspection, insert loading and boxing.
ExploreThe biggest items are the robot model and the dispensing system; 2K materials and heated systems increase scope. The number of fixtures and any vision also affect price.
Usually yes, if it has an external trigger and ideally a flow control interface. We review it during feasibility and check whether synchronisation with the robot will be good enough.
Total bead length, the application speed the material allows, how parts are loaded and any inspection steps. We run a trial to establish a realistic figure.
If fixture tolerance is not enough, a camera measures the part position and shifts the robot path. We decide from measurements on sample parts.
Paths are taught by hand guiding and a graphical interface. At commissioning we train your team to set up new part paths and handle routines such as nozzle cleaning.
Contact
Tell us about your process and we will reply with a free pre-feasibility and application proposal.