The machine never waits
The robot swaps parts as soon as the door opens, cutting idle time caused by breaks or other tasks.
03 · Solutions
A machine tending robot loads raw parts into a CNC machine, press or injection moulder and removes finished parts. Coborel Robotics integrates Dobot cobots with dual grippers, part trays and door signals so your machine keeps running without waiting for an operator, including breaks and shift ends.
Loading and unloading
Loading and unloading is one of the most common applications of cobots. Cobots automate the loading and unloading of products onto packaging lines, boosting these processes by completing multiple tasks simultaneously with speed and accuracy.
The robot swaps parts as soon as the door opens, cutting idle time caused by breaks or other tasks.
Your operator spends time on measuring, setup and quality while the robot tends the machines.
Swap gripper jaws and tray nests to move to a new part quickly.
The robot sits in front of the machine; no major changes to the machine itself are needed.
We record the machine model, door and chuck type, part size and weight, cycle time and target unattended run time.
We design a dual gripper with pneumatic or electric jaws to swap raw and finished parts in one visit.
We plan how the robot is fed: part tray, drawer feeder or conveyor.
We wire automatic door, chuck open/close and cycle start signals to the machine control and build the handshake logic.
We carry out the risk assessment, define the guarded zone in front of the machine, then commission and train operators.
Dobot CR10A is a 6-axis collaborative robot with a 10 kg payload and 1,300 mm reach.
Dobot CR5A is a general-purpose 6-axis collaborative robot with a 5 kg payload and 900 mm reach.
Dobot CR20A is a 6-axis collaborative robot with a 20 kg payload and 1,700 mm reach.
Coborel Robotics commissions Dobot cobots in metalworking and sheet metal plants for welding, CNC and press brake tending, grinding, deburring and cutting.
ExploreCoborel Robotics commissions Dobot cobots at automotive suppliers for CNC and press tending, screwdriving, welding, gluing and vision-based quality inspection.
ExploreCoborel Robotics installs Dobot cobots at plastic injection plants for part removal, sprue and flash trimming, visual inspection, insert loading and boxing.
ExploreCoborel Robotics installs compact Dobot cobots at electronics manufacturers for small-screw assembly, board and module loading, test station tending, dispensing and visual inspection.
ExploreWith most. The key factors are an automatic door, chuck control and an external signal interface, which can often be retrofitted. We review your machine model during feasibility.
The robot model, gripper type, part feeding system (tray, drawer, conveyor), changes on the machine side and safety equipment. Tending one machine or two also changes the scope.
It depends on feeder capacity, cycle time and tool life. We agree a target unattended time up front and size the feeder accordingly.
Usually only pick points and tray nests need updating. With hand guiding and a graphical interface your team can do this after training.
Each project gets a risk assessment based on ISO 10218 and ISO/TS 15066. Part weight, sharp edges and motion inside the machine determine speed limits and whether an area scanner is needed.
Contact
Tell us about your process and we will reply with a free pre-feasibility and application proposal.