Grinding

What you gain

Cobots are enhancing grinding. They utilize easy programming of consistent techniques to boost the quality and efficiency of surface refinement.

  • Force control
  • Sanding
  • Polishing
01

Constant contact force

Force control applies the same pressure despite small differences in part size and position.

02

Consistent surface quality

The same path, speed and overlap give similar roughness and appearance on every part.

03

Away from heavy, dusty work

The robot takes over work involving vibration, dust and repetitive motion.

04

Planned consumable changes

Abrasive paper or disc changes can be scheduled at intervals and optionally automated.

How it works

  1. 01

    Using samples we define material, current and target surface, stock removal and part variation.

  2. 02

    We select the spindle, sanding or polishing tool and a force sensor or passive force compensation unit.

  3. 03

    We decide whether the robot carries the tool to the part or the part to the tool, and design the fixture or gripper accordingly.

  4. 04

    We tune path, contact force, speed and number of passes, and approve the finish with you on samples.

  5. 05

    We assess dust extraction, sparks and rotating tool hazards, define measures and commission the cell.

When it fits

  • Deburring castings, weld seams, plastic and composite parts
  • Sanding and polishing stainless and aluminium surfaces
  • Parts or tools within the robot's reach and payload
  • Manual stations with quality variation or ergonomic issues

Frequently asked questions

What affects the price of a grinding robot?

The robot model, force control solution (sensor or compensation unit), tool type, automatic consumable change and dust extraction. Whether the robot carries the part or the tool also changes design and cost.

Why is force control needed?

Castings and welded parts vary in size; a robot following position alone removes too much in some places and too little in others. Force control keeps contact pressure constant to compensate.

How is cycle time determined?

It depends on surface area, stock removal, number of passes and tool speed. We run trials on samples to establish a realistic figure.

What is the payback period?

Payback depends on the number of shifts, the time spent on manual work, scrap and rework rates and project scope. During feasibility we build the calculation with your own data.

Can it work next to an operator?

In terms of robot motion it can be possible, but rotating tools, sparks and dust are separate hazards. Guarding and extraction are defined by a risk assessment based on ISO 10218 and ISO/TS 15066.

Contact

Where does a cobot fit in your line?

Tell us about your process and we will reply with a free pre-feasibility and application proposal.

Call WhatsApp Start a project